fix readme, requirements

master
Glenn K. Lockwood 4 years ago
parent 55ce68b3fe
commit 01856825a8
  1. 24
      README.md
  2. 1
      requirements.txt

@ -1,12 +1,17 @@
# Raspberry Pi Ansible # Raspberry Pi Ansible Playbook
Glenn K. Lockwood, October 2018 Glenn K. Lockwood, October 2018 - July 2020.
## Introduction ## Introduction
This is an Ansible configuration that configures a fresh Raspbian installation This is an Ansible configuration that configures a fresh Raspbian installation
on Raspberry Pi. It is intended to be run in local (pull) mode, where ansible on Raspberry Pi. It can be run in local (pull) mode, where ansible is running
is running on the same Raspberry Pi to be configured. on the same Raspberry Pi to be configured, or standard remote mode.
This playbook is known to run on Raspbian stretch (9) and Raspberry Pi OS
buster (10). I've not been able to run it on jessie because that ships with
Python 2.4, which is not supported by Ansible. It can run against jessie in
remote mode. See below.
## Bootstrapping on Raspbian ## Bootstrapping on Raspbian
@ -16,6 +21,12 @@ playbook relies on Ansible 2.8 or newer, which means you can no longer use
$ python3 -m venv --system-site-packages ansible_env $ python3 -m venv --system-site-packages ansible_env
If this fails, you may need to:
$ sudo apt install python3-apt python3-virtualenv
Then activate the environment and install ansible:
$ source ./ansible_env/bin/activate $ source ./ansible_env/bin/activate
# Make sure that pip will install into our virtualenv # Make sure that pip will install into our virtualenv
@ -38,7 +49,8 @@ This playbook can be run on localhost or against one or more remote hosts. The
former is good for a bare Raspberry Pi that was freshly provisioned using NOOBS former is good for a bare Raspberry Pi that was freshly provisioned using NOOBS
or the like, as you don't need a second host to act as the provisioning host. or the like, as you don't need a second host to act as the provisioning host.
The latter is the conventional way in which ansible is typically run and makes The latter is the conventional way in which ansible is typically run and makes
more sense if you want to configure a bunch of Raspberry Pis. more sense if you want to configure a bunch of Raspberry Pis. Depending on
the mode you intend to use, the configuration is slightly different.
### Local Mode ### Local Mode
@ -72,7 +84,7 @@ Raspberry Pi.
This is similar to local mode: This is similar to local mode:
(ansible_env) $ ansible-playbook --ask-vault-pass --inventory hosts.remote ./remote.yml (ansible_env) $ ansible-playbook --ask-vault-pass --ask-become-pass --inventory hosts.remote ./remote.yml
The playbook follows the same code path. The playbook follows the same code path.

@ -1,2 +1 @@
python-apt
ansible>=2.8 ansible>=2.8

Loading…
Cancel
Save