Ansible playbook for configuring a fresh install of Raspbian
You can not select more than 25 topics Topics must start with a letter or number, can include dashes ('-') and can be up to 35 characters long.
rpi-ansible/README.md

1.5 KiB

Raspberry Pi Ansible

Glenn K. Lockwood, October 2018

Introduction

This is an Ansible configuration that configures a fresh Raspbian installation on Raspberry Pi. It is intended to be run in local (pull) mode, where ansible is running on the same Raspberry Pi to be configured.

Bootstrapping on Raspbian

You will need ansible installed on the Raspberry Pi being configured.

$ sudo apt-get install ansible

Configuration

The macaddrs structure in roles/common/vars/main.yml maps the MAC address of a Raspberry Pi to its intended configuration state. Add your Raspberry Pi's MAC address to that structure and set its configuration accordingly.

Running the playbook

Then run the playbook:

$ sudo ansible-playbook local.yml 

The playbook will self-discover its settings, then idempotently configure the Raspberry Pi.

After running the playbook

This playbook purposely requires a few manual steps after running the playbook to ensure that it does not lock you out of your Raspberry Pi.

  1. While logged in as pi, sudo passwd glock (or whatever username you created) to set a password for that user. This is not required to log in as that user, but it is required to sudo as that user. You may also choose to set a password for the pi and/or root users.

  2. usermod --lock pi to ensure that the default user is completely disabled.

Acknowledgment

I stole a lot of knowledge from https://github.com/giuaig/ansible-raspi-config/.